RTS KP-97 Manuel de service Page 13
- Page / 52
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
3.2.2 DETERMINING THE ADDRESS, ADAM AND ADAM CS INTERCOMS
Determine the keypanel’s address using Table
7, page 48.
3.2.3 DETERMINING THE ADDRESS, ZEUS INTERCOM SYSTEMS
The address is the number (1-8) printed next to the connector on the back panel of the Zeus Frame.
(This number repeats for each group of 8 connectors. The intercom system is able to distinguish
between two keypanels set to the same address by the group where each one is connected.)
3.2.4 SETTING THE ADDRESS
1. While SET ADDR is displayed, click the SELECT control. ADDR 1 will display in the call
waiting window.
☞
Click: “Click” means to quickly press and release the SELECT or VOLUME control.
2. Rotate the SELECT control to display the address (ADDR1 through ADDR10) that you
determined above, then click SELECT again. While the address is being stored, the
alphanumeric displays and the call waiting window will show asterisks (
****
). Then, the
normal power-up indications will occur as described below. If you move the keypanel to a
new port and need to change the address at a later time, see “SERVICE MENU, SET ADDR”,
page
46.
3.3 POWER-UP INDICATIONS
After the correct keypanel address has been set, SET ADDR will no longer display at power-up.
Instead, the following indications will be given:
3.3.1 KEYPANEL WITH ALPHANUMERIC DISPLAYS
●
Alphanumeric displays: During a normal power-up, the alphanumeric displays will first
show asterisks (
****
). After a few moments the intercom key assignments will display. If the
keypanel cannot establish communication with the intercom system, all alphanumeric
displays will continue to show asterisks. Check the cable connection.
●
Unassigned keys: For each unassigned key the display will show dashes (----).
3.3.2 KEYPANEL WITHOUT ALPHANUMERIC DISPLAYS
The call waiting window will first display asterisks (
****
) then dashes (----). If the keypanel can-
not establish communications with the intercom system the call waiting window will continue to
show asterisks. Check the cable connection.
3.3.3 HDST / SPKR / PRGM / VOLUME INDICATORS
At power-up either HDST (Headset) or SPKR (Speaker) will be lit red to indicate which of these is
currently selected. The VOLUME indicator will be set to the currently programmed default level
for HDST or SPKR, whichever is selected. Also, if there is a program source connected (via the
EXT LINE IN connector of the optional KP-12 Rear Connector Module) the program sound will
activate at a preset level. To change the power-up preset configuration see “Headset / Speaker Se-
lection and Volume Adjustment”, page
15.
3.3.4 CALL AND MENU INDICATORS
At power-up, the CALL and MENU indicators should be off.
User Manual, DKP-8, DKP-12 and KP-12 Keypanels with Push-button Keys 13
Produits connexes et manuels pour Interphones de porte RTS KP-97
(90 pages)
(36 pages)Electrolux ERB34003W8 manuals
Owner’s manuals and user’s guides for Unknown Electrolux ERB34003W8.
We providing 6 pdf manuals Electrolux ERB34003W8 for download free by document types: User Manual
Commentaires sur ces manuels