RTS XCP-48-RJ45 Spécifications télécharger pdf (Page 147)

RJ-45 4-Wire to DB-25M Terminal Printer Cable

Cables

EIA-232 Terminal/Printer Cables, RJ-45 8-pin/4-wire to DB-

The wiring diagram for an RJ-45 8-pin to DB-25 terminal/printer cable using only 4 wires is shown in Table 1.

Table 1: EIA-232 RJ-45 8-pin to DB-25 terminal/printer cable using only 4 wires

From

RJ-45

Signal Direction Signal To DB-25

3 GND GND Shell

4 TxD

RxD 3

5 RxD

TxD 2

6SG

SG 7

1 DCD

RTS 4

* Arrows indicate which direction the signal is flowing

NOTES:

● This cable can only be used with Software Flow Control (Xon/Xoff).

● Some Unix operating systems require carrier to be present. If this is the case, altpin must be

turned on and the DCD-RTS wire added (in some cases it may be possible to wire DCD-RTS as the

fourth wire instead of GND).

1 2 ... 142 143 144 145 146 147 148 149 150 151 152

Pas de commentaire

RTS XCP-48-RJ45 Spécifications Page 147