RTS XCP-ADAM-MC Manuel d'utilisateur télécharger pdf (Page 20)

Call Signal Option Card

Installation

Use these instructions to install a Call Signal Option Card in

a SSA-424A that was originally ordered without it.

1. Disassemble the SSA-424A as previously described.

2. Assemble the standoffs to the circuit board using the

supplied screws and lock-washers.

3. Connect the supplied power cable from J8 on the option

card to J303 on the main board of the SSA-424A.

4. Insert the connectors on the option card into the

connectors on the main board.

5. Use the remaining screws and lock-washers to secure the

standoffs to the main board.

6. Reassemble the SSA-424A.

FIGURE 3. The Call Signal Option Card after installation in the

SSA-424A.

1 2 ... 15 16 17 18 19 20 21 22

Pas de commentaire

RTS XCP-ADAM-MC Manuel d'utilisateur Page 20