RTS KP-98 Manuel d'utilisateur télécharger pdf (Page 56)

IMPORTANT! - If you are using an earlier model KP-12, and your audio transmit board needs to be replaced, you will need

to make the following adjustments with the new audio transmit board for it to work properly.

There are four jumpers on the audio transmit board (9030-7725-500) - JP1, JP2, JP3, and JP4.

• If the new audio transmit board is used with the old audio controller board (9030-7504-000), jumpers should be installed

between pin 2 and 3 of JP1, JP2, JP3, and JP4.

• If the new audio transmit board (9030-7725-500) is used with the new audio controller board (9030-7725-000), jumpers

should be installed between pin 1 and 2 of JP1, JP2, JP3, and JP4

• Connect J10 on the new audio transmit board (9030-7725-500) with J11 on the new controller board (9030-7725-000)

through a 10-pin header.

1 2 ... 51 52 53 54 55 56 57 58 59 60

Pas de commentaire

RTS KP-98 Manuel d'utilisateur Page 56