RTS TM-2000 Manuel d'utilisateur Page 21

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 32
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 20
TM-2000 & MTM-2000 User Manual Installation 17
Bosch Security Systems, Inc.
User Manual
F.01U.193.264
Rev. 12
Checking IRQ Assignments
The PCI architecture is designed to allow multiple PCI cards to share an interrupt line. The TM-2000 software allows multiple
RS-485 cards to share an interrupt. However, an interrupt line which is used by an RS-485 card must not be shared with
another device. It is OK the same interrupt line to be assigned to an RS-485 card and to another PCI device which doesn’t
actually generate interrupts—for example, a VGA monitor.
To check for IRQ conflicts, do the following:
1. Power on the TM-2000.
2. Insert software CD into the CD-ROM drive.
3. Reboot the system by pressing the reset button on the front panel or the power switch on the back panel.
If the system does not boot from the CD, enter the system BIOS setup screen. Confirm the CD-ROM drive is
listed as the first boot sequence option.
Linux loads and information scrolls on the computer monitor until the prompt appears. The TM-2000 Trunk Master
Software prompt screen appears.
4. In the Option field, enter 3.
5. Press Enter () to confirm your selection.
A list of all PCI devices which use interrupts will display.
NOTE: Make sure the RS-485 ACCESS I/O cards are not sharing IRQ(s) with other PCI devices. The most common
conflict happens between the Ethernet card and the RS-485 cards.
TM-2000 Trunk Master Software Installation
There are three (3) operation modes for the TM-2000:
Stand-alone operation.
Active/standby operation, active by default.
Active/standby operation, standby by default.
All three (3) modes need to be loaded and tested.
NOTE: Prior to installing the Trunk Master Software on your TM-2000 check for IRQ conflicts. For more information
see, “Checking IRQ Assignments” on page 17.
TM-2000 Trunk Master Software
Options:
1. Run a demo version of the TM-2000 off the CD.
2. Install the TM-2000 software on the hard drive.
3. List PCI devices and check for interrupt conflicts.
Option?
Vue de la page 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Commentaires sur ces manuels

Pas de commentaire