RTS XCP-ADAM-MC Manuel d'utilisateur télécharger pdf (Page 27)

CHAPTER 3

RVON-C Card

Serial Port Programming

RVON Serial and Telnet Commands

RVON card programming can be done via direct serial or telnet connection. There are several physical connections to an

RVON board:

• Direct serial through custom debug cable (J7 6-pin bottom front)

The customer debug cable always functions as the general-purpose debug tool.

• Backcard DB-9 J1

The backcard DB-9 (must be disabled/enabled via a DIP Switch because it can also be used for serial port pass-

through. The backcard DB-9 can be used for a debug terminal when DIP switch 6 is switched to the Closed

position.

• Backcard RJ-45 J2(Telnet Only)

Setup

Serial Port 38.400 baud, No-flow control

Telnet IP Address, port 23

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 58 59

Pas de commentaire

RTS XCP-ADAM-MC Manuel d'utilisateur Page 27