RTS XCP-ADAM-MC Manuel d'utilisateur télécharger pdf (Page 37)

RVON Serial and Telnet Commands

RVON-8 card programming can also be done via direct serial or telnet connection. There are

several physical connections to an RVON board:

• Direct serial through custom debug cable (J20 6-pin bottom front)

The custom debug cable always functions as the general-purpose debug tool.

• Backcard DB-9 J2

The backcard DB-9 must be disabled/enabled via a DIP Switch because it can also be

used for serial port pass-thru. The backcard DB-9 can be used for a debug terminal when

DIP switch 6 is switched to the ON position.

• Backcard RJ-45 J1(Telnet only)

Setup:

Serial Port: 38,400 baud, No-flow control

Telnet: IP address, port 23

1 2 ... 32 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

RTS XCP-ADAM-MC Manuel d'utilisateur Page 37