RTS XCP-48-RJ45 Manuel d'utilisateur télécharger pdf (Page 31)

CHAPTER 4

Ethernet Setup for Cronus

Connecting Cronus to the PC and the Network

NOTE: The PC must be running version 2.06.07 or later of AZedit and have an Ethernet card installed.

Verify Cronus is connected to the PC using either a USB (universal) or RS-232 (ADAM standard) cable. The USB drivers can

be found in the AZedit software directory (C:\Telex\AZedit|V20701|USB). You may only use on USB connection (front panel

or back panel) at a time.

NOTE: Cronus can support up to 32 multiple sessions of AZedit on Ethernet.

To connect Cronus to the PC with a serial cable, do the following:

NOTE: For more information on Network Basics, “Basic Network Configuration” on page 59.

1. Open AZedit.

The Keypanels/Ports screen appears.

2. From the Options menu, select Ethernet Setup.

The Ethernet Setup Screen appears.

3. In the IP Address field, enter the IP Address for the Cronus system.

4. In the Network Mask field, enter the Network Mask number for the Cronus System.

5. Where appropriate, in the Default Gateway field, enter the gateway number for Cronus.

NOTE: If you do not know these numbers, your system administrator can give you the IP Address and

Netmask to use.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 106 107

Pas de commentaire

RTS XCP-48-RJ45 Manuel d'utilisateur Page 31