RTS XCP-48-RJ45 Manuel d'utilisateur télécharger pdf (Page 73)

Appendix B

RVON-C Card

Serial Port Programming

RVON Serial and Telnet Commands

RVON-C card programming can be done via direct serial or telnet connection. There are several physical connections to an

RVON-C card.

• Direct serial through custom debug cable (J7 6-pin bottom front)

The customer debug cable always functions as the general -purpose debug tool.

• Backcard DB-9 J1

The backcard DB-9 (must be disabled/enabled via a DIP Switch because it can also be used for serial port pass-

through.

The backcard DB-9 can be used for debug terminal when DIP Switch 6 is switched to the Closed position.

• Backcard RJ-45 J2 (Telnet Only)

Setup

Serial Port 38,400 baud, no flow control

Telnet IP Address, port 23

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 106 107

Pas de commentaire

RTS XCP-48-RJ45 Manuel d'utilisateur Page 73