RTS XCP-48-RJ45 Manuel d'utilisateur télécharger pdf (Page 49)

2. Right-click on an RVON-C card, and select RVON-C Configuration.

The RVON-C Configuration screen appears.

3. From the RVON-C drop down list, select the slot in which the RVON-C card resides, if it is not already selected.

4. In the IP Address field, enter the IP Address you have assigned to the RVON-C card.

5. In the Network Mask field, enter the Network Mask to which the RVON-C card is connected.

6. In the Default Gateway field, enter the Default Gateway Address (if applicable) of the network to which the RVON-

C card is connected.

A Default Gateway is only required if the RVON-C connections are between LANs.

Under Settings for Pass-Through Serial via Ethernet

7. In the Target IP Address field, enter the target IP Address of the device you want to connect to over Ethernet.

8. From the Serial Baud Rate drop down list, select the baud rate at which the data is transmitted.

Under Settings for Connected Devices

NOTE: You MUST configure the channel settings on each end of a connection and ensure the same codec and packet size

are selected at each end. Remember, the RVON-C card has different channels which can be configured.

9. In the RVON-C Channel drop down list, select the channel you want to use to communicate to another device across

the network.

10. In the Device IP Address field, enter the IP Address of the device to which you want to connect.

11. From the Device Type drop down list, select the type of device to which the RVON-C card is connecting.

12. From the Device Channel drop down list, select the channel on the device to which the RVON-C card will

communicate.

13. From the CODEC Type drop down list, select the CODEC type you want to use for this channel.

14. From the Packet Size drop down list, select the size of each audio packet.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 106 107

Pas de commentaire

RTS XCP-48-RJ45 Manuel d'utilisateur Page 49